EH Scott Philharmonic AM/FM
Posts: 1,199
Threads: 49
Joined: Oct 2017
City: Allendale, MI
The pre FM Philharmonics were 30 tubes. they included an audio expander and a scratch filter for the phono input. This one has the early FM band. 27 tubes on the tuner, 6 on the amp/PS. There is no audio expander as they needed the tube space for the FM section. As I said, the FM is the old 42-50 mhz frequency range. I just purchased a TV tuner "subber". These were a piece of test equipment that substituted for the TV tuner for test purposes. With a few modifications they can be made to convert the modern FM band into the old band. It takes 3 ranges to do that since the old band is only 8 mhz wide.
Messages In This Thread
RE: EH Scott Philharmonic AM/FM - by rfeenstra - 06-27-2019, 09:30 AM
Users browsing this thread: 2 Guest(s)
|
Recent Posts
|
Philco model 38 code 121 not receiving signal.
|
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM |
Philco model 38 code 121 not receiving signal.
|
A DMM is good enough.
One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM |
Testing a speaker and output transformer Trutone A2-G
|
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now.
Have better volu...murf — 03:43 PM |
Philco model 38 code 121 not receiving signal.
|
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM |
Philco model 38 code 121 not receiving signal.
|
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM |
Philco model 38 code 121 not receiving signal.
|
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM |
Philco model 38 code 121 not receiving signal.
|
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM |
Philco model 38 code 121 not receiving signal.
|
I've reinstalled the coil. Now IT'S ALIVE!!!!!!
I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM |
Philco model 38 code 121 not receiving signal.
|
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM |
PT 6 chassis screws size???
|
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM |
Who's Online
|
There are currently 1838 online users. [Complete List] » 2 Member(s) | 1836 Guest(s)
|
|
|

|