07-24-2019, 07:53 PM
I ended up moving the dial over abt 3/16 off of center and was able the get the bcb within 5kc or so (pretty impressive). The SW bands not so much. the two lower ones are within 100-150kc. Band 4 is pretty close but the same adjustment is used for band 5 and the procedure sez to split the difference make both band off abt 75kc. I guess in isn't horrible unfortunately the sw bands alignment is only at one end so you'll kinda stuck wherever the other end falls. May try add so small caps to get it to track better.
Haven't sorted the smoking resistor will flip the chassis over and give it the acid test and beat on it a little and see if it will do it again. At this point I'm a little nervous about connecting sm
More later...
Haven't sorted the smoking resistor will flip the chassis over and give it the acid test and beat on it a little and see if it will do it again. At this point I'm a little nervous about connecting sm
More later...
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
