Posts: 1,199
Threads: 49
Joined: Oct 2017
City: Allendale, MI
All the good radio shows are late at night. Like Ziggy's Midnight Blue, conspiracy theory shows, etc. I like working at night as it's quiet in the house with no phone interruptions. Once I focus in on a project, I tend to loose track of time. Before I know it, it's 2 or 3 am. The problem is, I have a hard time sleeping in in the morning. Eventually I have to play catch-up.
Messages In This Thread
RE: My 16B - by rfeenstra - 09-24-2019, 10:13 AM
Users browsing this thread: 4 Guest(s)
|
Recent Posts
|
My collection presentation
|
There is an article on my site that introduces the first portable radios in my collection. I have only provided a link t...Vlad95 — 01:17 PM |
Electrolytic restuffing/internals
|
Bridkarl
This specific cap you have is the easiset type to restuff.
I usually cut it at the upper border of the depr...morzh — 11:35 AM |
philco predicta
|
Hi CGL18,
First off, welcome to the Philco Phorum. I have not worked on a TV for a while but here are some givens:
...MrFixr55 — 08:22 AM |
Another amp build - here I go again!
|
Sweet!
I actually have a Dynaco Mark 4 that I had been running with 6L6s with no mods. Seemed to my 14-year-old head a...MrFixr55 — 12:57 AM |
PT-6 finished!!
|
Hi Gang,
Tube heaters are not "Ohmic" devices (that maintain specified resistance over wide temperature, c...MrFixr55 — 12:03 AM |
Electrolytic restuffing/internals
|
Look here:
Philco-F676-124
Vlad95 — 08:02 PM |
PT-6 finished!!
|
Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM |
Electrolytic restuffing/internals
|
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM |
Another amp build - here I go again!
|
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM |
Electrolytic restuffing/internals
|
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM |
Who's Online
|
There are currently 381 online users. [Complete List] » 2 Member(s) | 379 Guest(s)
|
|
|

|