Posts: 16,510
Threads: 572
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
Mike
I didn't have problems putting the dial back though I agree it is very inconvenient procedure.
But tension it does not seem to have much.
At least before it got in contact with the dial the tuning shaft and the spring moved freely and there was a gap between the spring and the rear of the box it is in.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Messages In This Thread
RE: Philco 570 Gramps Clock - by morzh - 03-30-2020, 06:25 PM
Users browsing this thread: 2 Guest(s)
|
Recent Posts
|
Electrolytic restuffing/internals
|
Look here:
Philco-F676-124
Vlad95 — 08:02 PM |
PT-6 finished!!
|
Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM |
Electrolytic restuffing/internals
|
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM |
Another amp build - here I go again!
|
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM |
Electrolytic restuffing/internals
|
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM |
philco predicta
|
If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM |
HiFi (Chifi) tube amp build - but my own design.
|
Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM |
philco predicta
|
Bob Anderson (Bandersontv) on Youtube would be the go-to guy on these. Lots of good videos. I don't know what model you ...TV MAN — 03:02 PM |
Electrolytic restuffing/internals
|
I have an issue on a non-Philco radio which I expect to run into on a whole set of Philcos and others.
I have an 8mf ...bridkarl — 01:17 PM |
Philco model 38 code 121 not receiving signal.
|
Thank you sir. I thought about it and decided to put it up in the arch support. I was looking at the chassis and didn't ...Stormlord5500 — 06:24 AM |
Who's Online
|
There are currently 545 online users. [Complete List] » 1 Member(s) | 544 Guest(s)
|
|
|

|