Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-350 portable
#16

I restored one a couple years ago.  One of the Candohm resistors was open so I removed the wire from inside and replaced with high wattage resistors. The handle can be bought online for about $25+ and I believe this is one that uses brass split rivets as fasteners. If not, then it will be fastened with threaded brass studs and nuts. I used a zener diode on the filament string as a safety precaution.

Rod


Messages In This Thread
Philco 46-350 portable - by ccomer1955 - 08-14-2015, 09:06 PM
RE: Philco 46-350 portable - by klondike98 - 08-14-2015, 09:47 PM
RE: Philco 46-350 portable - by ccomer1955 - 08-14-2015, 09:51 PM
RE: Philco 46-350 portable - by Radioroslyn - 08-14-2015, 10:31 PM
RE: Philco 46-350 portable - by sam - 08-15-2015, 01:25 PM
RE: Philco 46-350 portable - by codefox1 - 08-15-2015, 09:09 PM
RE: Philco 46-350 portable - by Ron Ramirez - 08-16-2015, 08:07 AM
RE: Philco 46-350 portable - by Radioroslyn - 08-16-2015, 08:39 AM
RE: Philco 46-350 portable - by ccomer1955 - 08-16-2015, 09:43 AM
RE: Philco 46-350 portable - by Arran - 08-18-2015, 12:22 AM
RE: Philco 46-350 portable - by Raleigh - 08-18-2015, 02:34 PM
RE: Philco 46-350 portable - by ccomer1955 - 08-18-2015, 06:23 PM
RE: Philco 46-350 portable - by codefox1 - 08-20-2015, 01:23 PM
RE: Philco 46-350 portable - by Paul Philco322 - 08-20-2015, 09:23 PM
RE: Philco 46-350 portable - by Terry Bills - 04-01-2020, 11:27 PM
RE: Philco 46-350 portable - by RodB - 04-02-2020, 10:42 AM
RE: Philco 46-350 portable - by klondike98 - 04-02-2020, 11:53 AM
RE: Philco 46-350 portable - by RodB - 04-02-2020, 12:34 PM
RE: Philco 46-350 portable - by radiodale - 05-31-2020, 10:28 PM
RE: Philco 46-350 portable - by 462ron - 06-01-2020, 07:24 AM
RE: Philco 46-350 portable - by W7FDR - 11-26-2020, 02:36 PM
Q5 - by nash - 12-17-2020, 02:06 AM
RE: Philco 46-350 portable - by SRv2 - 04-04-2024, 03:13 PM
RE: Philco 46-350 portable - by SRv2 - 04-06-2024, 08:23 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2234 online users. [Complete List]
» 5 Member(s) | 2229 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>