Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-1201 code 125
#20

After ordering all I finally installed the electrolytics 400v rated, few cents difference so no doubt, I re stuffed the other caps using a hot air gun to remove the interiors and some silicone for the sides, only 2 resistors were far out tolerances, all changed, this set was a little crowded in some places, I found some wires with the insulation melted from factory, one specially dangerous touching the mains that at first look was only underneath but was almost nude and touching the mains post...
Only left repair the speaker, and do alignment because the power on test was ok, even I can hear (but very low volume) one station without antenna connected to the coil .
Here are some photos of the result
Best regards 
https://ibb.co/9hhY9FG
https://ibb.co/tmnR2qC
https://ibb.co/dMvdSFD
https://ibb.co/z8ktN5q
https://ibb.co/kKDRJVx
https://ibb.co/frVpL5T
https://ibb.co/p4sq1PQ
https://ibb.co/zNR6Fm9
https://ibb.co/HK230GV
https://ibb.co/gjnLVTF
https://ibb.co/QHJR2hF
https://ibb.co/C2jtnCK


Messages In This Thread
Philco 46-1201 code 125 - by Jeepeto - 04-13-2020, 05:39 PM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-13-2020, 05:51 PM
RE: Philco 46-1201 code 125 - by falcon123 - 04-13-2020, 08:02 PM
RE: Philco 46-1201 code 125 - by Radioroslyn - 04-13-2020, 09:01 PM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-14-2020, 12:30 AM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-17-2020, 03:30 AM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-17-2020, 03:35 AM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-17-2020, 04:52 AM
RE: Philco 46-1201 code 125 - by falcon123 - 04-17-2020, 05:03 AM
RE: Philco 46-1201 code 125 - by Radioroslyn - 04-17-2020, 07:24 AM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-17-2020, 08:42 AM
RE: Philco 46-1201 code 125 - by Ron Ramirez - 04-17-2020, 01:51 PM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-18-2020, 03:34 AM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-18-2020, 08:15 AM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-20-2020, 09:34 AM
RE: Philco 46-1201 code 125 - by Radioroslyn - 04-20-2020, 09:10 PM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-22-2020, 06:58 AM
RE: Philco 46-1201 code 125 - by Radioroslyn - 04-22-2020, 02:52 PM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-22-2020, 05:20 PM
RE: Philco 46-1201 code 125 - by Jeepeto - 04-26-2020, 03:40 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
A little light Saturday positive about our hobby in our feed... My new every Saturday video about antique radio equipme...RadioSvit — 02:12 PM
Model 70 Cabinet Trim
musar , Well if you have any more questions feel free to post away . Sincerely Richardradiorich — 08:56 PM
Model 70 Cabinet Trim
Although I have not made any cabinets or cabinet parts for a couple of years, I still have some parts left over, includi...Steve Davis — 06:26 PM
philcorepairbench.com - shadow-meter
Thanks Ron. But I can't find those articles.fenbach — 02:43 PM
Model 70 Cabinet Trim
Thank you, Gary. Before making my original post, I had clicked on "Steve Davis Cabinets" only to find that it...musar — 02:25 PM
philco predicta
Welcome to the Phorum, cgl18! I am not your resource for television repair, but lots of friendly help is available here...GarySP — 02:12 PM
Model 70 Cabinet Trim
Welcome to the Phorum, musar! You can send Steve Davis a private message (PM). The site is at the top of the Home page...GarySP — 02:09 PM
Model 70 Cabinet Trim
How do I contact him? The only contact information for him I could find when searching online was a telephone number th...musar — 10:38 AM
philco predicta
Hello, good afternoon, I would like to ask what the possible problem could be if I don't have an image on the screen. I ...cgl18 — 10:19 AM
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM

[-]
Who's Online
There are currently 620 online users. [Complete List]
» 1 Member(s) | 619 Guest(s)
Avatar

>