Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 90 Cathedral stopped receiving
#1

I acquired a Philco 90 Cathedral.
With all your help I have progressed nicely, but have now taken 2 steps back...
The unit received stations when I got it. Now it does not.
It has always had a problem with the volume control. Very scratchy and intermittent.
(Should I replaced this? Can an original be located? Can I used a modern pot?)

Since, then, this is what I have done:
Changed power cord.
Added metal shield
Cleaned all the bugs and crap out and off of it.
   (I blew it off and used contact cleaner.)
Replaced the type 24 tube. (Det-Osc)
   (The tube did not light up anymore.)
   (The one under the 3 tube shield.)
Changed the Pilot light. (used an E10 6.3 volt)

Gee, here I thought I was doing great things for it, and now it is mad at me.
Maybe all the dirt was holding it together?

Anyway, any suggestions on where to start troubleshooting would be very appreciated.


Attached Files Image(s)
   

Scott Jensen
(ZboltMan)
[b]For maximum attention, nothing beats a good mistake[/b]


Messages In This Thread
Model 90 Cathedral stopped receiving - by zboltman - 08-27-2020, 09:09 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Electrolytic restuffing/internals
Look here: Philco-F676-124 Vlad95 — 08:02 PM
PT-6 finished!!
Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM
Electrolytic restuffing/internals
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM
Another amp build - here I go again!
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM
Electrolytic restuffing/internals
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM
philco predicta
If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM
HiFi (Chifi) tube amp build - but my own design.
Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM
philco predicta
Bob Anderson (Bandersontv) on Youtube would be the go-to guy on these. Lots of good videos. I don't know what model you ...TV MAN — 03:02 PM
Electrolytic restuffing/internals
I have an issue on a non-Philco radio which I expect to run into on a whole set of Philcos and others. I have an 8mf ...bridkarl — 01:17 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. I thought about it and decided to put it up in the arch support. I was looking at the chassis and didn't ...Stormlord5500 — 06:24 AM

[-]
Who's Online
There are currently 420 online users. [Complete List]
» 1 Member(s) | 419 Guest(s)
Avatar

>