10-21-2020, 09:23 PM
Ok so it would seem to me that you need to measure the resistance or r-314. It's either very high or open... Once that is sorted you should have hv on the red wire. OBTW one side should have hv on it now (pin 4) and the red wire side doesn't. This also assumes that pin 4 of the 6K6 has hv on too, it should and pin 3 on both 6K6's.
There is some good news coming...
There is some good news coming...
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
