[bobclausen]

Thanks and please don’t take offence but I still am confused. 

I can’t see any metal insert touching the can. There’s only the collar holding it in place and two wires from this cap. A red wire going to tube 80, not sure the pin# and a black wire that terminates at the B.C. Wire wound resistor part no. 33-3037. Photo of that wire enclosed. It is the black wire with a partial sleeve on it. If that goes to the transformer centertap I don’t know how to determine that. I am studying schematics but haven’t advanced enough to follow where everything goes.

I still am confused and would like to know where to connect the + and - of my cap and how to ground it.