|
RP3 help
12-09-2020, 06:42 PM
I would think that it would vary the RF output considerably through the range, 0 to 1meg. So if you measure from the high side (xtal) to ground you get 1 meg.? I have to ask - again, because these Philco controls are often the problem, especially if they have been "cleaned".
It may also vary the output freq. a little. What is you output freq?
« Next Oldest | Next Newest »
Messages In This Thread
RE: RP3 help - by Phlogiston - 12-09-2020, 01:52 PM
RE: RP3 help - by rjm - 12-09-2020, 02:08 PM
RE: RP3 help - by David - 12-09-2020, 03:51 PM
RE: RP3 help - by rjm - 12-09-2020, 04:57 PM
RE: RP3 help - by Radioroslyn - 12-09-2020, 05:00 PM
RE: RP3 help - by rjm - 12-09-2020, 05:05 PM
RE: RP3 help - by Radioroslyn - 12-09-2020, 05:18 PM
RE: RP3 help - by Phlogiston - 12-09-2020, 05:25 PM
RE: RP3 help - by rjm - 12-09-2020, 05:45 PM
RE: RP3 help - by rjm - 12-09-2020, 05:54 PM
RE: RP3 help - by Phlogiston - 12-09-2020, 06:01 PM
RE: RP3 help - by rjm - 12-09-2020, 06:17 PM
RE: RP3 help - by Phlogiston - 12-09-2020, 06:42 PM
RE: RP3 help - by morzh - 12-09-2020, 07:52 PM
RE: RP3 help - by rjm - 12-10-2020, 12:19 PM
RE: RP3 help - by rjm - 12-10-2020, 12:21 PM
Users browsing this thread: 1 Guest(s) |
