Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

ISO Tips: Refinishing Philco TV Cabinetry
#2

Hi and welcome,

Best I can tell your set is from 1963 and uses a 13N50 chassis. The free service info can be found here: https://worldradiohistory.com/Archive-Ri...963-TV.pdf  starting on pg 109. As for the marks on the top, I doubt it's any sort of solid wood probably some sort of decal over particle board. Would feel it to see if the grain is raised. If it is a little light sanding and artwork to draw in the sanded/missing wood grain. I'm sure others will have other suggestions on how to on the top issue.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!

Terry


Messages In This Thread
RE: ISO Tips: Refinishing Philco TV Cabinetry - by Radioroslyn - 06-08-2021, 01:12 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Cabinet Refinish
Roy; Personally I would have left the asbestos alone if it were my set, but you can find a modern substitute that som...Arran — 04:51 PM
Philco 71 Code 125
Looks like that might be the B- buss, so that would be correct.RodB — 01:32 PM
Philco 71 Code 125
I noticed on the code 121 schematic the center tap for the 6 volt winding and hv winding are tied together. Is this corr...dconant — 12:16 PM
Philco 45-6365 Universal IFT Instruction Manual
The Philco Parts Catalog for 1942 shows it as usable for 175 kHz, 260 kHz, and 465 kHz. The instructions will show how t...DaleHCook — 11:19 AM
Stromberg Carlson 1500 Squeal
Hello Rob, I agree with you—I have one here at my house that I need to check out. It’s way over-engineered just to make...radiorich — 11:05 AM
My Atwater Kent 84
Well getting around to restoring my AK84. Mike was a big part in me being able to snatch this one a few years ago. I won...462ron — 10:57 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
The engine is a B&S 23 inch cast Iron holds 2 quarts of oil. The Generator is a 4 pole 1800 rpm mine was made in 195...David — 10:51 AM
Philco 45-6365 Universal IFT Instruction Manual
Dale: Modified topic as suggested. It is not for a specific project. I found it in a box of stuff I recently purchased...GRG — 10:34 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
That looks a lot like an aircraft connector of some kind ... That is a MIL-5015 style connector, used in a wide v...DaleHCook — 10:19 AM
Philco P45-6365 Universal Transformer Instruction Manual
I would suggest changing the topic from "P45-6365 Universal Transformer" to "45-6365 Universal IFT."...DaleHCook — 10:08 AM

[-]
Who's Online
There are currently 2321 online users. [Complete List]
» 1 Member(s) | 2320 Guest(s)
Avatar

>