Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Unknown car radio :can anyone identify it?
#3

Hi Joe, Thank you for your wonderful detective work. I have searched through Riders and found the set : it is a Model 680 Hudson radio built by Zenith dated 1934.So the vibrator , rather than being a "it works so we'll fit it " substitute may well be the original for this set.This is probably an especially rare set in N.Z. Here in N.Z.  in the 1930s few people could afford cars and ,as in the U.S. ,the Hudson was a rare luxury car especially coming out of the Depression.There were ,though, many Essexs,the cheaper Hudson offshoot on N.Z. roads .So thank you again Joe. I'm so impressed with how you have narrowed the search down. The set is nearly going,but a stray loose wire off the top of the volume control had me foxed. I will let you know how it all plays out. Thanks.


Messages In This Thread
RE: Unknown car radio :can anyone identify it? - by Antipodal - 06-17-2021, 01:32 AM
Further musings on the autodyne - by Antipodal - 06-21-2021, 09:32 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM
Philco model 38 code 121 not receiving signal.
Thankyou for the kind words sir. I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM

[-]
Who's Online
There are currently 738 online users. [Complete List]
» 1 Member(s) | 737 Guest(s)
Avatar

>