07-17-2021, 02:10 PM
...but it could be in the Why didn't I think of this Sooner department
Here's an idea that I hope you can use. Another engine stand! But, it is very strudy and (I hope) adaptable. Works good on this little Delco.
Easy for a fabrication shop with an NC laser or plasma and sheet metal brake. I have model and .dxf files if needed. I suppose you could do this by hand with a bandsaw and drill press.
The Prototype looks a little different than the print, because I lengthed the Front 1", and the Back 1" for better Center of Gravity and roll to the top without hitting the knobs.
Thank you,
Simon
Here's an idea that I hope you can use. Another engine stand! But, it is very strudy and (I hope) adaptable. Works good on this little Delco.
Easy for a fabrication shop with an NC laser or plasma and sheet metal brake. I have model and .dxf files if needed. I suppose you could do this by hand with a bandsaw and drill press.
The Prototype looks a little different than the print, because I lengthed the Front 1", and the Back 1" for better Center of Gravity and roll to the top without hitting the knobs.
Thank you,
Simon
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
