01-30-2022, 02:24 PM
The 3-D printed bezel arrived and with a little filing and scraping to make it fit into the cabinet I think it will work out just fine. Not knowing quite what the original looked like since it was pretty well shrunken and crumbled this will do for now. I also went back and pulled the bias battery that I had mounted under the chassis with a "D" cell and mounted a "AA" on the back for easier access. If it does leak it will be easy to fix and if the next owner wants to change it, the original button cell holder is still in place under the chassis.
[Image: https://www.dropbox.com/s/rj94ztrcghjasn....jpg?raw=1]
[Image: https://www.dropbox.com/s/mkg2gsa1x8filz....jpg?raw=1]
[Image: https://www.dropbox.com/s/rj94ztrcghjasn....jpg?raw=1]
[Image: https://www.dropbox.com/s/mkg2gsa1x8filz....jpg?raw=1]
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
