1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Atwater Kent 82
ducretet
Member
***
Posts: 81
Threads: 24
Joined: Aug 2018
City: LAVERN-SUBIRATS State, Province, Country: ESPAÑA
#11

04-09-2022, 06:52 AM
I have already seen the error !!!!!
You were right, John. The fault was related to the control tube circuit. The potentiometer is correct: 550 ohms. The fault was in the 670 ohm resistor. It read 1,000 ohms. Totally out of tolerance. I had not noticed.
The radio works perfectly !!!!
Thanks for the help.
Regards,
Ferran
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Atwater Kent 82 - by ducretet - 11-29-2021, 01:36 PM
RE: Atwater Kent 82 - by Arran - 11-30-2021, 06:20 AM
RE: Atwater Kent 82 - by ducretet - 11-30-2021, 07:04 AM
RE: Atwater Kent 82 - by Phlogiston - 11-30-2021, 11:13 AM
RE: Atwater Kent 82 - by Eliot Ness - 12-03-2021, 10:42 AM
RE: Atwater Kent 82 - by MrFixr55 - 04-04-2022, 11:09 PM
RE: Atwater Kent 82 - by radiorich - 04-04-2022, 11:55 PM
RE: Atwater Kent 82 - by ducretet - 04-08-2022, 01:40 AM
RE: Atwater Kent 82 - by MrFixr55 - 04-08-2022, 05:39 PM
RE: Atwater Kent 82 - by ducretet - 04-08-2022, 05:53 PM
RE: Atwater Kent 82 - by ducretet - 04-09-2022, 06:52 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2160 online users. [Complete List]
» 1 Member(s) | 2159 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)