Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Philco 610
#55

I would use an ohm meter set on it's lowest range and measure across the stator section of the tuning capacitor to chassis ground. The antenna section of the stator can be measured from the grid cap of the 6A7. The osc side can be measured from pin 5 of the 6A7. This is if you don't have good access to the tuning cap. As you tune the cap from one end of the dial to the other on the bcb you should see 4-6 ohms (normal). If the see 0 ohms you've got the bent plate...

I'd check that 1st.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!

Terry


Messages In This Thread
Philco 610 - by JimB - 03-09-2022, 11:15 AM
RE: Philco 610 - by GarySP - 03-09-2022, 01:56 PM
RE: Philco 610 - by Mondial - 03-09-2022, 03:13 PM
RE: Philco 610 - by David - 03-09-2022, 03:27 PM
RE: Philco 610 - by TV MAN - 03-09-2022, 06:32 PM
RE: Philco 610 - by JimB - 03-09-2022, 08:04 PM
RE: Philco 610 - by radiorich - 03-09-2022, 08:06 PM
RE: Philco 610 - by mikethedruid - 03-09-2022, 08:52 PM
RE: Philco 610 - by Mondial - 03-09-2022, 09:22 PM
RE: Philco 610 - by GarySP - 03-09-2022, 10:08 PM
RE: Philco 610 - by MrFixr55 - 03-09-2022, 11:16 PM
RE: Philco 610 - by JimB - 03-10-2022, 11:58 AM
RE: Philco 610 - by radiorich - 03-10-2022, 10:06 PM
RE: Philco 610 - by klondike98 - 03-10-2022, 10:59 PM
RE: Philco 610 - by Radioroslyn - 03-11-2022, 08:51 PM
RE: Philco 610 - by JimB - 03-11-2022, 11:55 PM
RE: Philco 610 - by JimB - 03-12-2022, 01:50 PM
RE: Philco 610 - by Radioroslyn - 03-12-2022, 03:33 PM
RE: Philco 610 - by Ron Ramirez - 03-12-2022, 03:49 PM
RE: Philco 610 - by klondike98 - 03-12-2022, 03:53 PM
RE: Philco 610 - by Radioroslyn - 03-12-2022, 04:00 PM
RE: Philco 610 - by JimB - 03-12-2022, 05:05 PM
RE: Philco 610 - by klondike98 - 03-12-2022, 05:38 PM
RE: Philco 610 - by Steve Davis - 03-12-2022, 05:52 PM
RE: Philco 610 - by radiorich - 03-12-2022, 11:19 PM
RE: Philco 610 - by JimB - 03-13-2022, 09:32 AM
RE: Philco 610 - by David - 03-13-2022, 11:04 AM
RE: Philco 610 - by Mondial - 03-13-2022, 12:17 PM
RE: Philco 610 - by radiorich - 03-23-2022, 01:06 AM
RE: Philco 610 - by JimB - 03-23-2022, 08:12 AM
RE: Philco 610 - by RodB - 03-23-2022, 09:15 AM
RE: Philco 610 - by mikethedruid - 03-23-2022, 01:10 PM
RE: Philco 610 - by gregb - 03-23-2022, 08:27 PM
RE: Philco 610 - by Mondial - 03-23-2022, 09:02 PM
RE: Philco 610 - by JimB - 03-23-2022, 09:06 PM
RE: Philco 610 - by mikethedruid - 03-23-2022, 09:07 PM
RE: Philco 610 - by MrFixr55 - 03-24-2022, 07:46 AM
RE: Philco 610 - by radiorich - 03-24-2022, 09:37 AM
RE: Philco 610 - by JimB - 03-24-2022, 03:56 PM
RE: Philco 610 - by mikethedruid - 03-24-2022, 04:48 PM
RE: Philco 610 - by radiorich - 03-24-2022, 06:56 PM
RE: Philco 610 - by TV MAN - 03-24-2022, 07:08 PM
RE: Philco 610 - by JimB - 03-24-2022, 09:54 PM
RE: Philco 610 - by radiorich - 03-24-2022, 09:55 PM
RE: Philco 610 - by JimB - 03-28-2022, 08:57 AM
RE: Philco 610 - by Radioroslyn - 03-28-2022, 04:51 PM
RE: Philco 610 - by Daniel Bingamon - 04-03-2022, 11:08 AM
RE: Philco 610 - by Radioroslyn - 04-03-2022, 12:50 PM
RE: Philco 610 - by JimB - 04-03-2022, 01:22 PM
RE: Philco 610 - by JimB - 04-12-2022, 11:27 AM
RE: Philco 610 - by Mondial - 04-12-2022, 01:35 PM
RE: Philco 610 - by JimB - 04-12-2022, 02:37 PM
RE: Philco 610 - by JimB - 04-12-2022, 05:37 PM
RE: Philco 610 - by JimB - 04-19-2022, 11:20 AM
RE: Philco 610 - by Radioroslyn - 04-19-2022, 02:42 PM
RE: Philco 610 - by JimB - 04-19-2022, 02:54 PM
RE: Philco 610 - by JimB - 04-19-2022, 04:57 PM
RE: Philco 610 - by Mondial - 04-19-2022, 05:41 PM
RE: Philco 610 - by JimB - 04-19-2022, 06:15 PM
RE: Philco 610 - by Radioroslyn - 04-19-2022, 09:08 PM
RE: Philco 610 - by JimB - 05-05-2022, 02:44 PM
RE: Philco 610 - by Mondial - 05-05-2022, 02:48 PM
RE: Philco 610 - by JimB - 05-05-2022, 04:19 PM
RE: Philco 610 - by radiorich - 05-05-2022, 07:57 PM
RE: Philco 610 - by JimB - 05-22-2022, 03:03 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco P45-6365 Universal Transformer Instruction Manual
Can anyone guide me to where this may be found?GRG — 03:00 PM
54C Complete Teardown/Rebuild
I don't think that I have encountered a 12Z3 before, curious how it uses one of those but includes a #43, which is a 25 ...Arran — 02:17 PM
HiFi (Chifi) tube amp build - but my own design.
It's the other forum. I'm also in DIY, but mostly read there. Honestly, I kinda jumped into this without much thought to...TV MAN — 10:43 AM
Philco 71 Code 125
Hello,  I am in need of a schematic for this radio. Mine has the three separate circular tube shields and a shadow me...dconant — 08:06 AM
Stromberg Carlson 1500 Squeal
And life just keeps getting more complicated.dconant — 07:57 AM
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM

[-]
Who's Online
There are currently 1650 online users. [Complete List]
» 1 Member(s) | 1649 Guest(s)
Avatar

>