Magnavox 155B

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Magnavox 155B

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

06-19-2022, 05:37 PM

ALL, i have 3 separate units that go with this

AMP-101A power supply and Amp
Cr-188 SW and BCST receiver
CR-206E FM convertor

I have the power supply hooked to receiver.. all seems to work correctly

But do not really know what antennas to hook up I have the loop antenna that goes with it..

There is connections for the loop and also an antenna..

Also a switch in chassis that says loop / antenna..

on convertor there are connections for a antenna and plug to the receiver. I have NO FM No noise at all.

Where to look?

Skip

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Magnavox 155B - by vecher - 06-19-2022, 05:37 PM

RE: Magnavox 155B - by vecher - 06-20-2022, 09:05 PM

RE: Magnavox 155B - by vecher - 06-23-2022, 03:36 PM

RE: Magnavox 155B - by mikethedruid - 06-23-2022, 04:04 PM

RE: Magnavox 155B - by RodB - 06-23-2022, 08:30 PM

RE: Magnavox 155B - by Radioroslyn - 06-23-2022, 08:39 PM

RE: Magnavox 155B - by vecher - 06-24-2022, 09:37 AM

RE: Magnavox 155B - by RodB - 06-24-2022, 02:26 PM

RE: Magnavox 155B - by vecher - 07-03-2022, 10:11 AM

RE: Magnavox 155B - by RodB - 07-03-2022, 12:27 PM

RE: Magnavox 155B - by Radioroslyn - 07-03-2022, 01:06 PM

RE: Magnavox 155B - by vecher - 07-04-2022, 09:51 AM

RE: Magnavox 155B - by Radioroslyn - 07-06-2022, 08:07 AM

RE: Magnavox 155B - by vecher - 07-14-2022, 05:21 PM

RE: Magnavox 155B - by Radioroslyn - 07-14-2022, 07:29 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

Who's Online

There are currently 2145 online users. [Complete List]
» 1 Member(s) | 2144 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me