1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Stewart-Warner A72T3
Masonparker
Junior Member
**
Posts: 47
Threads: 10
Joined: Nov 2020
City: CHESAPEAKE State, Province, Country: VA
#1

07-23-2022, 01:32 PM
Just recapped a Stewart-Warner A72T3 the AM portion of the radio works great.  The FM side has nothing just a low low  steady buzz.  During the initial investigation I noticed the 12H6 tube was replaced with a 6H6 tube  I have since ordered the correct tube but the radio plays great with the 6H6.   I looked into SMD but I don't see where they used silver mica in this radio. Any help would be greatly appreciated

Thanks


Attached Files
.pdf Scan_0152.pdf Size: 1.26 MB  Downloads: 240
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Stewart-Warner A72T3 - by Masonparker - 07-23-2022, 01:32 PM
RE: Stewart-Warner A72T3 - by Paul Philco322 - 07-23-2022, 01:45 PM
RE: Stewart-Warner A72T3 - by David - 07-23-2022, 04:54 PM
RE: Stewart-Warner A72T3 - by RodB - 07-23-2022, 05:30 PM
RE: Stewart-Warner A72T3 - by morzh - 07-23-2022, 07:27 PM
RE: Stewart-Warner A72T3 - by Masonparker - 07-23-2022, 08:33 PM
RE: Stewart-Warner A72T3 - by Radioroslyn - 07-23-2022, 08:56 PM
RE: Stewart-Warner A72T3 - by David - 07-23-2022, 09:17 PM
RE: Stewart-Warner A72T3 - by MrFixr55 - 07-23-2022, 09:22 PM
RE: Stewart-Warner A72T3 - by Masonparker - 07-24-2022, 06:54 AM
RE: Stewart-Warner A72T3 - by morzh - 07-24-2022, 10:19 AM
RE: Stewart-Warner A72T3 - by Masonparker - 07-29-2022, 04:19 PM
RE: Stewart-Warner A72T3 - by Radioroslyn - 07-30-2022, 08:01 AM
RE: Stewart-Warner A72T3 - by Masonparker - 11-29-2022, 10:07 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2137 online users. [Complete List]
» 1 Member(s) | 2136 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)