1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 39-6C
radiola
Member
***
Posts: 64
Threads: 10
Joined: Dec 2010
City: Baltimore, MD
#7

05-24-2011, 07:29 PM
The voltage readings of the pins of the 41 tube were with the common lead of the voltmeter against the negative end of the first power cap, which is 10 uf, taking place of the original 12 uf. I got nothing when I measured them to chassis. If you care to look into the belly of the beast, you can find it here: https://picasaweb.google.com/lh/photo/pX...directlink

Thanks, Mike.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 39-6C - by radiola - 05-23-2011, 07:58 PM
Re: Philco 39-6C - by Ron Ramirez - 05-23-2011, 08:04 PM
Re: Philco 39-6C - by 7estatdef - 05-23-2011, 08:32 PM
Re: Philco 39-6C - by BILL - 05-24-2011, 03:47 PM
Re: Philco 39-6C - by radiola - 05-24-2011, 06:35 PM
Re: Philco 39-6C - by codefox1 - 05-24-2011, 07:21 PM
Re: Philco 39-6C - by radiola - 05-24-2011, 07:29 PM
Re: Philco 39-6C - by Ron Ramirez - 05-24-2011, 08:14 PM
Re: Philco 39-6C - by codefox1 - 05-24-2011, 09:14 PM
Re: Philco 39-6C - by Ed Locker - 05-25-2011, 08:59 AM
Re: Philco 39-6C - by 7estatdef - 05-25-2011, 05:55 PM
Re: Philco 39-6C - by Ron Ramirez - 05-25-2011, 07:09 PM
Re: Philco 39-6C - by radiola - 05-26-2011, 02:44 AM
Re: Philco 39-6C - by codefox1 - 05-26-2011, 01:44 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2143 online users. [Complete List]
» 2 Member(s) | 2141 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration