[mbhdesign]

Found it. Here’s a link to a Schematic PDF of the EA Dynamotor.

http://www.nostalgiaair.org/PagesByModel...013995.pdf

On page three of this PDF the Dynamotor is described along with the following recommendation:

“The Dynamotor housing or box can be conveniently located in the floor of the car. Simply cut a hole 6 1/8” by 8 7/16” in the floor and drop the box in place from the top.”

Still no picture of the housing or box yet, but this gives you a little more to go on.

Also, it seems Philco supplied one type of control unit that could be steering column mounted or dashboard mounted. Page two of the “PA Packard” PDF schematic I sent earlier explains in detail under the heading “Control Unit”

Here’s that particular pdf link again: http://www.nostalgiaair.org/PagesByModel...014113.pdf

Hope that helps!