1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Making a Set of Base Moulding
Steve Davis
Phorum Expert
*****
Posts: 1,411
Threads: 72
Joined: Oct 2007
City: Linn Creek, MO
#1

07-02-2023, 09:46 AM
This is a "how to" (or at least the way I do it) on making base moulding. I will be making a one off set for an Atwater Kent 627.

   
Badly damaged original base.

   
I start by making a pattern using 1/8 ply. First a notch is cut roughly the shape of the original trim but, a little larger.

   
Cellophane tape is applied to an undamaged section of the original trim to protect it.
M R Radios   C M Tubes
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Making a Set of Base Moulding - by Steve Davis - 07-02-2023, 09:46 AM
RE: Making a Set of Base Moulding - by morzh - 07-02-2023, 11:43 AM
RE: Making a Set of Base Moulding - by DaleHCook - 07-03-2023, 10:11 AM
RE: Making a Set of Base Moulding - by morzh - 07-03-2023, 01:12 PM
RE: Making a Set of Base Moulding - by klondike98 - 07-04-2023, 09:56 AM
RE: Making a Set of Base Moulding - by Arran - 07-09-2023, 05:27 PM
RE: Making a Set of Base Moulding - by radiorich - 09-21-2023, 09:12 AM



Users browsing this thread:
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM
Philco model 38 code 121 not receiving signal.
Good news everyone! I think I have found everything I need for rewinding the antenna coil primary. I found some pla...Stormlord5500 — 09:40 AM
Philco Battery-WWII vintage
My younger sister went to SUNY Plattsburg NY, (BS, MS, RN) in the late 1970sabout 10 min from the Northern NY / Canada b...MrFixr55 — 07:59 AM
Philco Battery-WWII vintage
Hello Bob, What Amazing find! Sincerely Richardradiorich — 10:19 PM
Testing a speaker and output transformer Trutone A2-G
Hi Murf, Do this: Monitor between ground and one plate of the rectifier while playing the radio.  Do the same with ...MrFixr55 — 09:51 PM
Philco Battery-WWII vintage
Mike; I take it that Soviet cars did not come equipped with block heaters, hence the hot oil change? Where I lived in...Arran — 08:42 PM
Philco 42-345 Restoration/Repair
The more the better. (Within reasonable limits.) 2-5 times more is no problem in this case.Vlad95 — 03:50 PM
Philco 42-345 Restoration/Repair
Thanks, RodB and Vlad95, I was mainly trying to figure out this capacitor to locate a replacement, Vlad thank you for...osanders0311 — 03:44 PM

[-]
Who's Online
There are currently 1164 online users. [Complete List]
» 1 Member(s) | 1163 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration