Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 10 car radio head key
#2

Hi Keandkafu,

In general, the Key Code usually has nothing to do with the brand of key, but is a code for how the notches in the key are cut. Car manufacturers used to give a tab with the key code for your car. However, considering t\the fact that this radio is 90+ years old, I don't think you will be able to get a key made by the code, even if you found it.

Can you disassemble the head or is the state of the lock preventing that?

I have a sneaking suspicion that if you bring the unit to a locksmith, he or she will be able to pick the lock rather quickly. I believe that the sole purpose of the lock was not to prevent theft but to prevent unauthorized operation of the radio (The driver could control who used the radio if he / she allowed someone ese to drive or park the car.). These radios had a rather high draw on the battery, and neither battery capacity or generator current were very high. In addition, the first versions of car radios ran off of B Batteries for plate voltage and the car battery for filament voltages instead of a vibrator supply or dynamotor that ran off the car battery.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55


Messages In This Thread
Philco 10 car radio head key - by Keandkafu - 10-18-2024, 02:33 PM
RE: Philco 10 car radio head key - by MrFixr55 - 10-19-2024, 11:37 PM
RE: Philco 10 car radio head key - by falcon123 - 02-02-2025, 05:52 AM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2164 online users. [Complete List]
» 1 Member(s) | 2163 Guest(s)
Avatar

>