1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 46-480 Power Supply
jrblasde
Senior Member
****
Posts: 287
Threads: 16
Joined: Jan 2024
City: Tulsa State, Province, Country: Oklahoma
#20

12-27-2024, 11:07 AM
All are fair points. I’ll utilize the higher voltage rating. I might as well spend a few dollars more to protect the transformer. We’ve worked so hard to get these transformers cleaned up!
Joseph

Philco 46-480
Philco 49-906
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 46-480 Power Supply - by jrblasde - 08-18-2024, 09:20 AM
RE: Philco 46-480 Power Supply - by RodB - 08-18-2024, 10:26 AM
RE: Philco 46-480 Power Supply - by MrFixr55 - 08-18-2024, 10:34 AM
RE: Philco 46-480 Power Supply - by jrblasde - 08-18-2024, 10:36 AM
RE: Philco 46-480 Power Supply - by jrblasde - 08-18-2024, 11:01 AM
RE: Philco 46-480 Power Supply - by morzh - 08-18-2024, 11:30 AM
RE: Philco 46-480 Power Supply - by jrblasde - 08-18-2024, 07:31 PM
RE: Philco 46-480 Power Supply - by morzh - 08-18-2024, 09:16 PM
RE: Philco 46-480 Power Supply - by MrFixr55 - 08-19-2024, 08:52 AM
RE: Philco 46-480 Power Supply - by morzh - 08-19-2024, 09:47 AM
462ron - by 462ron - 08-20-2024, 07:56 AM
RE: Philco 46-480 Power Supply - by jrblasde - 08-20-2024, 06:10 PM
RE: Philco 46-480 Power Supply - by morzh - 08-20-2024, 08:06 PM
RE: Philco 46-480 Power Supply - by jrblasde - 12-26-2024, 03:47 PM
RE: Philco 46-480 Power Supply - by tbone - 12-27-2024, 08:37 AM
RE: Philco 46-480 Power Supply - by jrblasde - 12-27-2024, 08:54 AM
RE: Philco 46-480 Power Supply - by morzh - 12-27-2024, 10:38 AM
RE: Philco 46-480 Power Supply - by jrblasde - 12-27-2024, 10:54 AM
RE: Philco 46-480 Power Supply - by morzh - 12-27-2024, 10:58 AM
RE: Philco 46-480 Power Supply - by jrblasde - 12-27-2024, 11:07 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2145 online users. [Complete List]
» 1 Member(s) | 2144 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration