Philco 46-480 Electronic Restoration
Posts: 1,863
Threads: 119
Joined: May 2008
City: Omak
State, Province, Country: WA
Hello Joseph,
Very nice I will have to remember that KiCAD
I personally restuff the bakelite blocks not just they look right but the factory wiring stays the same and makes it just that much easier to work on and to trouble shoot .
Sincerely Richard
P.S. the Philco 38-10T that I am working on right now had only one bakelite block and it was also the safety capacitors one .
Messages In This Thread
RE: Philco 46-480 Electronic Restoration - by radiorich - 01-12-2025, 10:45 PM
Users browsing this thread:
|
Recent Posts
|
Philco 42-345 Restoration/Repair
|
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM |
Philco 42-345 Restoration/Repair
|
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM |
Philco model 38 code 121 not receiving signal.
|
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM |
Testing a speaker and output transformer Trutone A2-G
|
The equivalent of one short turn is basically the same as that of a shorted load.
If it is the primary's turn, then the ...morzh — 03:53 PM |
Testing a speaker and output transformer Trutone A2-G
|
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM |
Philco model 38 code 121 not receiving signal.
|
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM |
Philco model 38 code 121 not receiving signal.
|
Well why not! :lol:Stormlord5500 — 03:14 PM |
Philco model 38 code 121 not receiving signal.
|
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM |
Testing a speaker and output transformer Trutone A2-G
|
morzh
Short-circuited turns can be considered as a half-dead transformer.
But on this case transformer will hot and s...Vlad95 — 11:01 AM |
Testing a speaker and output transformer Trutone A2-G
|
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM |
Who's Online
|
There are currently 2182 online users. [Complete List] » 1 Member(s) | 2181 Guest(s)
|
|
|

|