Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-640 bandswitch ?
#15

I suppose that if every thing down stream from the antenna transformers is OK, the radio should “work”.

If, you clip a wire (small antenna) on to the RF tube grid cap you should get some reception. You are bypassing the antenna transformers. See the schematic and you’ll see what I mean. It will work better with them (transformers) but ought to work to some degree without them. What could go wrong Icon_biggrin ?

Others may have suggestions too.

Can't think of anything witty.
Greg O.
Whitehall, PA


Messages In This Thread
37-640 bandswitch ? - by georgetownjohn - 01-18-2025, 01:15 PM
RE: 37-640 bandswitch ? - by RodB - 01-18-2025, 02:19 PM
RE: 37-640 bandswitch ? - by morzh - 01-18-2025, 03:52 PM
RE: 37-640 bandswitch ? - by georgetownjohn - 01-18-2025, 05:12 PM
RE: 37-640 bandswitch ? - by morzh - 01-18-2025, 07:05 PM
RE: 37-640 bandswitch ? - by morzh - 01-18-2025, 07:53 PM
RE: 37-640 bandswitch ? - by RodB - 01-18-2025, 08:51 PM
RE: 37-640 bandswitch ? - by georgetownjohn - 01-19-2025, 11:00 AM
RE: 37-640 bandswitch ? - by morzh - 01-19-2025, 01:13 PM
37-640 part IDd - by georgetownjohn - 01-19-2025, 03:40 PM
RE: 37-640 bandswitch ? - by Greg - 01-19-2025, 05:24 PM
RE: 37-640 bandswitch ? - by Greg - 01-20-2025, 12:06 AM
RE: 37-640 bandswitch ? - by Greg - 01-20-2025, 01:59 PM
RE: 37-640 bandswitch ? - by georgetownjohn - 01-20-2025, 02:53 PM
RE: 37-640 bandswitch ? - by georgetownjohn - 01-20-2025, 02:57 PM
RE: 37-640 bandswitch ? - by Greg - 01-20-2025, 03:40 PM
RE: 37-640 bandswitch ? - by georgetownjohn - 01-20-2025, 04:36 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM
Philco model 38 code 121 not receiving signal.
Good news everyone! I think I have found everything I need for rewinding the antenna coil primary. I found some pla...Stormlord5500 — 09:40 AM
Philco Battery-WWII vintage
My younger sister went to SUNY Plattsburg NY, (BS, MS, RN) in the late 1970sabout 10 min from the Northern NY / Canada b...MrFixr55 — 07:59 AM

[-]
Who's Online
There are currently 1741 online users. [Complete List]
» 4 Member(s) | 1737 Guest(s)
AvatarAvatarAvatarAvatar

>