Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

370 Norman Bel Geddes trim pieces
#3

One method that some have used is to get some hardwood dowel, of the appropriate diameter, and cutting a flat onto one side to duplicate missing portions of the bead. I don't know if anyone is duplicating strips of molding for these, It could be done, but I think the way they made it was by running boards through a shaper, or molding head cutter, and then cutting it into strips, likely gluing and nailing it on.
Regards
Arran


Messages In This Thread
370 Norman Bel Geddes trim pieces - by Max T - 03-08-2025, 08:26 PM
RE: 370 Norman Bel Geddes trim pieces - by morzh - 03-08-2025, 09:02 PM
RE: 370 Norman Bel Geddes trim pieces - by Arran - 03-09-2025, 05:03 PM
RE: 370 Norman Bel Geddes trim pieces - by GarySP - 03-12-2025, 12:03 AM
RE: 370 Norman Bel Geddes trim pieces - by Max T - 03-12-2025, 06:34 AM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2206 online users. [Complete List]
» 1 Member(s) | 2205 Guest(s)
Avatar

>