Posts: 892
Threads: 51
Joined: Feb 2013
City: Shenandoah,
State, Province, Country: Pennsylvania
Here is my Zenith 7H920, similar to your H725. It is a great sounding set with more volume than I would expect from a SE output design. I tried doing a sweep alignment of the FM section but could never get the marker blip (10.7Mhz) to show up to set the discriminator properly. You can see the results in my post about Eico 368 Sweep generator in the “Test Equipment” section of the phorum. I was able to get aligned on the money using the crystal marker only and it sounds great. When you get to aligning yours it should be doable with a non-sweep generator. Looking forward to your progress!
Ron
Bendix 0626. RCA T64 Philco 20B
Philco 41-250. Philco49-500
GE 201. Philco 39-25
Motorola 61X13. Philco 46-42 Crosley 52TQ
Philco 37-116. Philco 70
AK 35 Philco 46-350
Philco 620B. Zenith Transoceanic B-600
Philco 60B. Majestic 50
Philco 52-944. AK 84
Messages In This Thread
462ron - by 462ron - 03-23-2025, 08:54 AM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
5U4 vs 5Z4 tubes
|
Well this is a Hallicrafters SX/9 circa 1936.
No real issues so far although I dodged a real bullet with a cap that was...bridkarl — 07:59 AM |
5U4 vs 5Z4 tubes
|
The pinout is the same but the 5U4 has a 3 amp filament, verses 2 amps or less on the 5Z4. I think that the pinout of a ...Arran — 12:04 AM |
Philco 42-345 Restoration/Repair
|
By the way.
osanders0311
Take a look here: Dial cord stringing Guides
May be here you can fount correct string settin...Vlad95 — 11:15 PM |
5U4 vs 5Z4 tubes
|
5U4 and 5Z4 almost identical. I think nothing happened if you left 5U4 instedad 5Z4 long time.
Just heater current 5U4 ...Vlad95 — 11:02 PM |
Philco 42-345 Restoration/Repair
|
Hello Vlad95 ,
Very Funny !
Sincerely Richardradiorich — 11:01 PM |
Philco 42-345 Restoration/Repair
|
RodB
You are European yourself :evil:
I'm Canadian for the last 30 years :snowman:
But not Yankee :lol: Vlad95 — 10:49 PM |
Philco 42-345 Restoration/Repair
|
The band switch selects different oscillator coils for the band selected. I would look for a bad connection in the switc...RodB — 10:31 PM |
Philco 42-345 Restoration/Repair
|
Hang in there...PaulPaul Philco322 — 09:30 PM |
Philco 42-345 Restoration/Repair
|
The thrill is gone again, thought I was close to being done with it. Well Friday it was receiving broadcast, Saturday mo...osanders0311 — 07:47 PM |
Help with Supreme 599
|
Iam getting closer to fixing it. I bumped
Up the tranny voltage to get 5v on the 80 tube. I gan get the needle to move ...daveone23 — 03:41 PM |
Who's Online
|
There are currently no members online. |
|

|