Posts: 1,385
Threads: 45
Joined: Nov 2017
City: Menlo Park
State, Province, Country: CA
The PSU filter cap arrived today (thank you USPS!) so I will work on that later.
Meanwhile, I have the dial, speaker grille and badges cleaned up and refitted. It is starting to look like a radio again.
One thing I need is something to replace the heat insulation that was inside the top of the case, where the OP tube would deliver most heat. Any thoughts on what to use here?
I don't hold with furniture that talks.
Messages In This Thread
RE: Zenith H725 - by EdHolland - 04-02-2025, 06:42 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Philco 42-345 Restoration/Repair
|
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM |
Philco 42-345 Restoration/Repair
|
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM |
Philco model 38 code 121 not receiving signal.
|
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM |
Testing a speaker and output transformer Trutone A2-G
|
The equivalent of one short turn is basically the same as that of a shorted load.
If it is the primary's turn, then the ...morzh — 03:53 PM |
Testing a speaker and output transformer Trutone A2-G
|
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM |
Philco model 38 code 121 not receiving signal.
|
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM |
Philco model 38 code 121 not receiving signal.
|
Well why not! :lol:Stormlord5500 — 03:14 PM |
Philco model 38 code 121 not receiving signal.
|
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM |
Testing a speaker and output transformer Trutone A2-G
|
morzh
Short-circuited turns can be considered as a half-dead transformer.
But on this case transformer will hot and s...Vlad95 — 11:01 AM |
Testing a speaker and output transformer Trutone A2-G
|
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM |
Who's Online
|
There are currently 2299 online users. [Complete List] » 3 Member(s) | 2296 Guest(s)
|
|
|

|