Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-480 Electronic Restoration

Got my replacement signal generator in the mail today! I was able to finish alignment of the IF section. I’ve got some trouble in the RF section though—I can’t receive AM, shortwave, or FM RF signals. The alignment procedures for the RF section don’t seem to be working. 

Either I have a bad 7F8 converter tube or I have a miswire in the RF chassis. I will first assume a miswire, so I will comb back through to make sure everything matches the schematic. If it does, I’ll replace the tube.

I can feed an AM signal at 455kHz to a loop antenna sitting just beside the loop in the cabinet, and the radio picks it up and passes it through to be demodulated. But I can’t do the same for a signal in the AM bandwidth.

Joseph

Philco 46-480
Philco 49-906


Messages In This Thread
462ron - by 462ron - 02-25-2025, 08:24 AM
462ron - by 462ron - 04-09-2025, 07:07 AM
462ron - by 462ron - 04-09-2025, 08:08 AM
RE: Philco 46-480 Electronic Restoration - by jrblasde - 04-13-2025, 09:58 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2145 online users. [Complete List]
» 1 Member(s) | 2144 Guest(s)
Avatar

>