Philco 46-480 Electronic Restoration
Posts: 287
Threads: 16
Joined: Jan 2024
City: Tulsa
State, Province, Country: Oklahoma
I’m making progress with the alignment. It was a combination of needing to solder the connection on pin 3 of the BC oscillator coil (oops!) and needing to replace the 7F8 tube. Luckily I had a spare 7F8 in the 48-482 I have sitting in my attic.
Here’s a couple of links to videos demonstrating AM and FM. Haven’t picked up anything on shortwave just yet. I still need to finish up with alignment of the RF section, but this is so exciting after eight months of work!
https://youtube.com/shorts/wpDEIsRydR8?s...37rEL9TApC
https://youtube.com/shorts/4ATUTwN2IN0?s...Dc1KLdPuLo
Joseph
Philco 46-480
Philco 49-906
Messages In This Thread
RE: Philco 46-480 Electronic Restoration - by jrblasde - 04-14-2025, 10:21 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Philco 42-345 Restoration/Repair
|
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM |
Philco 42-345 Restoration/Repair
|
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM |
Philco model 38 code 121 not receiving signal.
|
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM |
Testing a speaker and output transformer Trutone A2-G
|
The equivalent of one short turn is basically the same as that of a shorted load.
If it is the primary's turn, then the ...morzh — 03:53 PM |
Testing a speaker and output transformer Trutone A2-G
|
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM |
Philco model 38 code 121 not receiving signal.
|
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM |
Philco model 38 code 121 not receiving signal.
|
Well why not! :lol:Stormlord5500 — 03:14 PM |
Philco model 38 code 121 not receiving signal.
|
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM |
Testing a speaker and output transformer Trutone A2-G
|
morzh
Short-circuited turns can be considered as a half-dead transformer.
But on this case transformer will hot and s...Vlad95 — 11:01 AM |
Testing a speaker and output transformer Trutone A2-G
|
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM |
Who's Online
|
There are currently 2296 online users. [Complete List] » 3 Member(s) | 2293 Guest(s)
|
|
|

|