Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-420 code 128
#1

Greetings all:
I am in the process of completing the basic electronic upgrading on the above model but having some difficulty identifying the value of one of the resistors under the 35Y4 tube. I tried using a 1200ohm 1 watt &, then a 2 Watt but when I play the radio the resistor begins to smoke and burn.
Most items - connections, tubes, other resistor values have be double tested.
The schematics for the code 128 is difficult to locate.
The 46-420 code 121 is readily available but has a different tube layout.
Any suggestions to the possible value of this resistor offered by more experience restorers are most welcomed.


Messages In This Thread
46-420 code 128 - by decoflair - 08-18-2011, 07:44 PM
Re: 46-420 code 128 - by Ron Ramirez - 08-18-2011, 08:38 PM
Re: 46-420 code 128 - by decoflair - 08-20-2011, 06:23 AM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2279 online users. [Complete List]
» 4 Member(s) | 2275 Guest(s)
AvatarAvatarAvatarAvatar

>