10-13-2025, 02:25 PM
Hi Terry here are my results.
First item - 3.8 ohms. I did rewind that coil.
Second item - No erratic movement detected. It is a new pot from Mark Opat.
Third item - 2.3 ohms.
Fourth item - 2.9 meg. I replaced the 4 meg resistor (#16) with a 2 meg based on another post.
Fifth item - Block 20 as well as 9 were missing from my radio. I have checked the location of the block 20 caps four times and they are correctly wired. I did add the block 9 caps as shown in the schematic.
A third go around with the regenerative condenser helped a little bit. So I guess I'm good then. Maybe I'm expecting too much.
Dan
First item - 3.8 ohms. I did rewind that coil.
Second item - No erratic movement detected. It is a new pot from Mark Opat.
Third item - 2.3 ohms.
Fourth item - 2.9 meg. I replaced the 4 meg resistor (#16) with a 2 meg based on another post.
Fifth item - Block 20 as well as 9 were missing from my radio. I have checked the location of the block 20 caps four times and they are correctly wired. I did add the block 9 caps as shown in the schematic.
A third go around with the regenerative condenser helped a little bit. So I guess I'm good then. Maybe I'm expecting too much.
Dan
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
