Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x


1937 Sky Rover - Belmont
#19

Sloppy proof of concept??? That is rather clean IMHO, great job.

I think that most RF sections of tuning caps are 10-365 uF.  Hooking a loop antenna directly to the antenna and ground terminals will yield a low signal.  Try a Ferrite loop antenna meant for broadcast band, preferably for a tube type radio and install it in lieu of the antenna coil.  Remove the secondary of the antenna coil, usually connected to the "RF section" of the tuning cap and the AVC line and replace it with the loopstick.  However, this may be tricky if the set is Broadcast / Shortwave.

There are 3 advantages to ferrite loopsticks:
  • They are directional, like any loop antenna.  Turning the loopstick or the entire radio in a direction that
    maximizes signal and minimizes interference can make a big difference in signal quality over even a goodoutdoor antenna.
  • Ferrite loopsticks have an advantage over loop coil type antennas for certain types of interference.
  • Ferrite loopsticks are more compact than loop antennas.  This may allow for more inconspicuous
    installation and may allow for rotating the loopstick instead of the whole radio, important for desiredplacement of the radio for room decor reasons

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55


Messages In This Thread
1937 Sky Rover - Belmont - by RichG - 10-10-2025, 03:55 PM
RE: 1937 Sky Rover - Belmont - by Paul Philco322 - 10-10-2025, 05:17 PM
RE: 1937 Sky Rover - Belmont - by radiorich - 10-10-2025, 07:00 PM
RE: 1937 Sky Rover - Belmont - by Arran - 10-10-2025, 10:06 PM
RE: 1937 Sky Rover - Belmont - by RichG - 10-11-2025, 01:23 AM
RE: 1937 Sky Rover - Belmont - by Arran - 10-11-2025, 11:41 PM
RE: 1937 Sky Rover - Belmont - by RichG - 10-12-2025, 01:06 PM
RE: 1937 Sky Rover - Belmont - by Arran - 10-12-2025, 07:02 PM
RE: 1937 Sky Rover - Belmont - by RichG - 11-24-2025, 04:10 PM
RE: 1937 Sky Rover - Belmont - by Paul Philco322 - 11-24-2025, 09:27 PM
RE: 1937 Sky Rover - Belmont - by RodB - 11-24-2025, 10:36 PM
RE: 1937 Sky Rover - Belmont - by RichG - 11-25-2025, 12:28 AM
RE: 1937 Sky Rover - Belmont - by radiorich - 11-25-2025, 01:07 AM
RE: 1937 Sky Rover - Belmont - by MrFixr55 - 11-25-2025, 01:43 AM
462ron - by 462ron - 11-25-2025, 08:43 AM
RE: 1937 Sky Rover - Belmont - by RichG - 11-25-2025, 01:28 PM
RE: 1937 Sky Rover - Belmont - by RichG - 11-25-2025, 09:25 PM
RE: 1937 Sky Rover - Belmont - by Paul Philco322 - 11-25-2025, 10:08 PM
RE: 1937 Sky Rover - Belmont - by MrFixr55 - 11-26-2025, 07:15 AM
462ron - by 462ron - 11-26-2025, 07:43 AM
RE: 1937 Sky Rover - Belmont - by RodB - 11-26-2025, 11:19 AM
RE: 1937 Sky Rover - Belmont - by RichG - 11-26-2025, 04:25 PM
462ron - by 462ron - 11-26-2025, 05:06 PM
RE: 1937 Sky Rover - Belmont - by RichG - 11-26-2025, 08:06 PM
462ron - by 462ron - 11-27-2025, 10:22 AM
RE: 1937 Sky Rover - Belmont - by RichG - 12-10-2025, 08:07 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
That looks a lot like an aircraft connector of some kind, even if it's a U.S.N power supply. I have a book somewhere abo...Arran — 02:56 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
hello david, I have a similar generator in my collection that features a cast iron, single-cylinder Briggs & Stratt...radiorich — 01:00 AM
under chassis parts locator diagram for 1938 Zenith 9s262
Has anyone gone to the trouble of creating an under chassis parts locator image?  Yes, I can identify components by foll...bobloney — 08:57 PM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
Try looking at this site the book mark is for a old generator that I was given. David    https://radionerds.com/index.ph...David — 08:36 PM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
Hello Everyone, I am looking for voltage identification for all the pin positions on the socket of a CRV-20130 power su...Tonym4704 — 08:16 PM
Philco P45-6365 Universal Transformer Instruction Manual
Can anyone guide me to where this may be found?GRG — 03:00 PM
54C Complete Teardown/Rebuild
I don't think that I have encountered a 12Z3 before, curious how it uses one of those but includes a #43, which is a 25 ...Arran — 02:17 PM
HiFi (Chifi) tube amp build - but my own design.
It's the other forum. I'm also in DIY, but mostly read there. Honestly, I kinda jumped into this without much thought to...TV MAN — 10:43 AM
Philco 71 Code 125
Hello,  I am in need of a schematic for this radio. Mine has the three separate circular tube shields and a shadow me...dconant — 08:06 AM
Stromberg Carlson 1500 Squeal
And life just keeps getting more complicated.dconant — 07:57 AM

[-]
Who's Online
There are currently no members online.

>