12-08-2025, 07:51 PM
So took a look at it and I don’t see anything obvious. I also touched a screwdriver to the middle post of my volume control which has a .01 cap and nothing. Last night it was playing ok just not as loud as I think it should when it just stopped. All the tubes are lit some just barely but exactly like they were last night. I will have to get a set of needle Leeds before I try poking around in this thing to check voltage though. Do I go negative to case when I do that? Thanks for the schematic. The one I had was super hard to read. Any idea where I should start when checking the voltage?




