Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need Grille cloth help
#9

Depending on the cabinet the 87 and 95 may have used a leaf pattern grille cloth which was never reproduced, at least in the low boy cabinets without the fretwork in the grille, the highboys sometimes used a cloth with trees in it, it was reproduced but I can't remember who offered it. When you can't find the original cloth anyhow it's an opportunity to visit the fabric store and improvise, plus the stuff at the fabric store is usually cheaper then the reproduction grille cloth. If both options are historically wrong anyhow why not use the cheaper of the two.
Regards
Arran


Messages In This Thread
Need Grille cloth help - by 7estatdef - 08-22-2011, 03:37 PM
Re: Need Grille cloth help - by Ron Ramirez - 08-22-2011, 03:55 PM
Re: Need Grille cloth help - by 7estatdef - 08-22-2011, 04:37 PM
Re: Need Grille cloth help - by Ron Ramirez - 08-22-2011, 06:05 PM
Re: Need Grille cloth help - by SamTanner - 09-14-2011, 04:03 PM
Re: Need Grille cloth help - by Ron Ramirez - 09-14-2011, 10:26 PM
Re: Need Grille cloth help - by SamTanner - 09-14-2011, 10:36 PM
Re: Need Grille cloth help - by Ron Ramirez - 09-14-2011, 10:40 PM
Re: Need Grille cloth help - by Arran - 09-15-2011, 07:47 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2144 online users. [Complete List]
» 1 Member(s) | 2143 Guest(s)
Avatar

>