Zenith 6S254 Intermitten Reception
Posts: 18,427
Threads: 622
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
Have you measured the taps' voltages on the Antenna secondary, as I asked?
Now, you having 7 Ohms there, think about it:
The AVC voltage is created via R5, a 1 MOhm resistor and C2, a 0.047uF cap. Forget the cap, it is the filter.
Now, you have, in essence, a 1 MOhm in series with 7 Ohm (your coil), cap to cap (no pun intended).
And you drop 0.3V, if your measurements were correct.
To drop 0.3V across 7 Ohms you need ... you need...you need a whopping 42mA current. There is no one there who can pull that.
So. Re-measure, with all the taps. While working.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Messages In This Thread
RE: Zenith 6S254 Intermitten Reception - by morzh - 05-23-2026, 06:26 PM
Users browsing this thread: 9 Guest(s)
|
|
Recent Posts
|
|
Philco 71 Code 125
|
| This might be one of those cases where it's a ground to an AC voltage and B- to DC.RodB — 08:22 PM |
|
Philco 71 Code 125
|
| Really Rod? I know you would not steer me wrong but AI say this is a short circuit? What if I moved the 6 volt center ta...dconant — 06:40 PM |
|
54C Cabinet Refinish
|
| Roy;
Personally I would have left the asbestos alone if it were my set, but you can find a modern substitute that som...Arran — 04:51 PM |
|
Philco 71 Code 125
|
| Looks like that might be the B- buss, so that would be correct.RodB — 01:32 PM |
|
Philco 71 Code 125
|
| I noticed on the code 121 schematic the center tap for the 6 volt winding and hv winding are tied together. Is this corr...dconant — 12:16 PM |
|
Philco 45-6365 Universal IFT Instruction Manual
|
| The Philco Parts Catalog for 1942 shows it as usable for 175 kHz, 260 kHz, and 465 kHz. The instructions will show how t...DaleHCook — 11:19 AM |
|
Stromberg Carlson 1500 Squeal
|
| Hello Rob,
I agree with you—I have one here at my house that I need to check out. It’s way over-engineered just to make...radiorich — 11:05 AM |
|
My Atwater Kent 84
|
| Well getting around to restoring my AK84. Mike was a big part in me being able to snatch this one a few years ago. I won...462ron — 10:57 AM |
|
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
|
| The engine is a B&S 23 inch cast Iron holds 2 quarts of oil. The Generator is a 4 pole 1800 rpm mine was made in 195...David — 10:51 AM |
|
Philco 45-6365 Universal IFT Instruction Manual
|
| Dale: Modified topic as suggested. It is not for a specific project. I found it in a box of stuff I recently purchased...GRG — 10:34 AM |
|
Who's Online
|
| There are currently no members online. |
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
