Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x


Philco 53-958 selenium rectifier
#2

Ni Joe,

In a series circuit, current is constant. In your example, the current is 0.375A anywhere in the series circuit. If P = EI (Wattage = Voltage X Current), then, like you said, the total dissipated power through the 27 Ohms is 3.7W, However, since you have a 22 Ohm and a 3.5 Ohm resistor, the current through each is the same, but the 22 Ohm resistor will dissipate more power than the 3.5 Ohm resistor. There is absolutely no problem with the 3.5 Ohm resistor. The 22 Ohm one will dissipate more because the voltage drop across that resistor is much more than the voltage drop across the 3.5 Ohm resistor. However, you are safe. I would feel a little better if the 22 Ohm resistor was a 10 watt job but you are still OK here.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55


Messages In This Thread
Philco 53-958 selenium rectifier - by Joe Rossi - 07-04-2026, 07:50 PM
RE: Philco 53-958 selenium rectifier - by MrFixr55 - 07-04-2026, 08:49 PM
RE: Philco 53-958 selenium rectifier - by morzh - 07-04-2026, 09:46 PM
RE: Philco 53-958 selenium rectifier - by RodB - 07-05-2026, 11:19 AM
RE: Philco 53-958 selenium rectifier - by morzh - 07-05-2026, 11:27 AM
462ron - by 462ron - 07-06-2026, 07:15 AM
RE: Philco 53-958 selenium rectifier - by morzh - 07-06-2026, 09:33 AM
RE: Philco 53-958 selenium rectifier - by David - 07-06-2026, 02:21 PM
RE: Philco 53-958 selenium rectifier - by morzh - 07-06-2026, 03:24 PM
RE: Philco 53-958 selenium rectifier - by RodB - 07-06-2026, 04:06 PM
RE: Philco 53-958 selenium rectifier - by Arran - 07-06-2026, 06:27 PM
RE: Philco 53-958 selenium rectifier - by morzh - 07-06-2026, 08:55 PM
RE: Philco 53-958 selenium rectifier - by morzh - 07-07-2026, 08:07 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 71 Code 125
Looks like that might be the B- buss, so that would be correct.RodB — 01:32 PM
Philco 71 Code 125
I noticed on the code 121 schematic the center tap for the 6 volt winding and hv winding are tied together. Is this corr...dconant — 12:16 PM
Philco 45-6365 Universal IFT Instruction Manual
The Philco Parts Catalog for 1942 shows it as usable for 175 kHz, 260 kHz, and 465 kHz. The instructions will show how t...DaleHCook — 11:19 AM
Stromberg Carlson 1500 Squeal
Hello Rob, I agree with you—I have one here at my house that I need to check out. It’s way over-engineered just to make...radiorich — 11:05 AM
My Atwater Kent 84
Well getting around to restoring my AK84. Mike was a big part in me being able to snatch this one a few years ago. I won...462ron — 10:57 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
The engine is a B&S 23 inch cast Iron holds 2 quarts of oil. The Generator is a 4 pole 1800 rpm mine was made in 195...David — 10:51 AM
Philco 45-6365 Universal IFT Instruction Manual
Dale: Modified topic as suggested. It is not for a specific project. I found it in a box of stuff I recently purchased...GRG — 10:34 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
That looks a lot like an aircraft connector of some kind ... That is a MIL-5015 style connector, used in a wide v...DaleHCook — 10:19 AM
Philco P45-6365 Universal Transformer Instruction Manual
I would suggest changing the topic from "P45-6365 Universal Transformer" to "45-6365 Universal IFT."...DaleHCook — 10:08 AM
Stromberg Carlson 1500 Squeal
And life just keeps getting more complicated. By dconant. Dittos'Jimradio — 08:01 AM

[-]
Who's Online
There are currently 2138 online users. [Complete List]
» 1 Member(s) | 2137 Guest(s)
Avatar

>