[morzh]

The flush cutter does a good job but I need a narrower one to get under the tabs that have some solder at one end.
So I ordered the rest of the gauges (I have 10mm, so I ordered 4mm, 6mm and 8mm).

The iron set at 300W did the job but I did struggle a bit. The chassis is thick and is a massive heatsink; also, the device is fairly heavy, which is OK in itself, but coupled with the necessity to keep the trigger pressed makes the hand a bit tired if held for more than a minute. But it is fine, it works eventually.

So when the narrower cutter comes, I will use it and the iron to first lift the tab a bit, and then will finish the job with the pry bar and eventually pliers.