1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-116 Getting Working or Complete Restoration??
Guest
Unregistered
 
#5

08-22-2006, 07:24 PM
Pete,
Thanks for the helpful tips. I have located some tubes and will be replacing that 5X4. Also, I have ordered the Cap Kit from the place recomended by Terry earlier on this board. Hope you frequent this site as I am sure I will have questions. This will be a winter project and I plan to take my time and do it right. Right now I am just lining up what I need and getting everything ready.
I have in the last few years restored a couple of Kenwood TS-900 radios. Still actually working on some cosmetics. It was the radio I wanted 30 odd years ago and could never afford. The receiver and audio on those radios are incredable! Send me an email and I can send you a couple of pics of the rigs. w1dg@aol.com
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
38-116 Getting Working or Complete Restoration?? - by Guest - 08-20-2006, 09:18 AM
[No subject] - by Terry Judkins - 08-20-2006, 11:20 PM
[No subject] - by Guest - 08-21-2006, 08:04 PM
5X4 position - by AI2V - 08-22-2006, 10:05 AM
[No subject] - by Guest - 08-22-2006, 07:24 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2267 online users. [Complete List]
» 4 Member(s) | 2263 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration