Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x


Philco A361 Antenna
#6

As far as I know they basically removed the 6.3 volt vibrator power supply and added a 117 volt, AC mains transformer in it's place, electrically if not physically. It's possible that the antenna coil may have an open primary if reception is very weak, other then that I would check the tubes, resistors, and alignment. I would also go back through and see if maybe a wiring error was made, it's not uncommon with a bulk recapping for this to happen. I noticed that there is a .01 uf cap coupling the car antenna to the primary of the antenna coil as well. https://philcoradio.com/library/download...20Book.pdf
Regards
Arran


Messages In This Thread
Philco A361 Antenna - by radiodale - 10-22-2025, 09:05 PM
RE: Philco A361 Antenna - by MrFixr55 - 10-23-2025, 04:31 AM
RE: Philco A361 Antenna - by MZip - 07-25-2026, 03:58 PM
RE: Philco A361 Antenna - by patrician56 - 07-30-2026, 12:58 PM
RE: Philco A361 Antenna - by klondike98 - 07-30-2026, 01:33 PM
RE: Philco A361 Antenna - by Arran - 07-30-2026, 02:26 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Cabinet Refinish
Roy; Personally I would have left the asbestos alone if it were my set, but you can find a modern substitute that som...Arran — 04:51 PM
Philco 71 Code 125
Looks like that might be the B- buss, so that would be correct.RodB — 01:32 PM
Philco 71 Code 125
I noticed on the code 121 schematic the center tap for the 6 volt winding and hv winding are tied together. Is this corr...dconant — 12:16 PM
Philco 45-6365 Universal IFT Instruction Manual
The Philco Parts Catalog for 1942 shows it as usable for 175 kHz, 260 kHz, and 465 kHz. The instructions will show how t...DaleHCook — 11:19 AM
Stromberg Carlson 1500 Squeal
Hello Rob, I agree with you—I have one here at my house that I need to check out. It’s way over-engineered just to make...radiorich — 11:05 AM
My Atwater Kent 84
Well getting around to restoring my AK84. Mike was a big part in me being able to snatch this one a few years ago. I won...462ron — 10:57 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
The engine is a B&S 23 inch cast Iron holds 2 quarts of oil. The Generator is a 4 pole 1800 rpm mine was made in 195...David — 10:51 AM
Philco 45-6365 Universal IFT Instruction Manual
Dale: Modified topic as suggested. It is not for a specific project. I found it in a box of stuff I recently purchased...GRG — 10:34 AM
Plug Voltages Needed For A 1943 CRV-20130 Power Supply
That looks a lot like an aircraft connector of some kind ... That is a MIL-5015 style connector, used in a wide v...DaleHCook — 10:19 AM
Philco P45-6365 Universal Transformer Instruction Manual
I would suggest changing the topic from "P45-6365 Universal Transformer" to "45-6365 Universal IFT."...DaleHCook — 10:08 AM

[-]
Who's Online
There are currently no members online.

>