Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x


Restauración Philco 54 desde España
#2

Hi Daniel,

This set covered the US broadcast band of approximately 550-1,500 KHZ and about 1.5 to about 4MHz (200-75M). Is the Broadcast band totally obsolete in Spain and other parts of Europe?It is in danger here but is currently quite active here.

There are inexpensive low power AM transmitters available as kits, preassembled or plans for 1930's era "Phono Oscillators" that can be used to generate RF signals receivable on this radios, using a CD Player, MP3 Player or computer as a source of audio. The USA regulatory Agency, the FCC (Federal Communications Commission) allows the use of these without a license as long as the power level is under 100 mW, the antenna and ground wires don't exceed a certain length and that no one complains about interference. Check for local, national and EC regulations for your location.

There are 2 ways to restore the set:

Using the appropriate schematics and specifications for the substituted tubes, ensure that the wiring is correct, recap and test.

OR

Rebuild the set to the original schematic.

Regarding the asbestos, it is dangerous only if it is inhaled. If it is stabilized, it is not as dangerous. If you are worried about it and want to remove it, thoroughly wet it down or tape over it before pulling the staples that hold it in place, carefully remove, place in a sealed bag and dispose per your local regulations. You will then have to fashion an appropriate insulator such as fiberglass

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
"Let us begin to do good"- St. Francis

Best Regards, 

MrFixr55


Messages In This Thread
RE: Restauración Philco 54 desde España - by MrFixr55 - 08-17-2026, 11:24 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 71 Code 125
Technically, that's C-. B- is chassis ground. The resistor between chassis ground and the HV center tap makes the HV c...MrFixr55 — 11:24 PM
54C Cabinet Refinish
hello Roy, I’d follow Arran’s suggestion and use automotive gasket material, which I keep around for situations like th...radiorich — 10:22 PM
Philco 71 Code 125
This might be one of those cases where it's a ground to an AC voltage and B- to DC.RodB — 08:22 PM
Philco 71 Code 125
Really Rod? I know you would not steer me wrong but AI say this is a short circuit? What if I moved the 6 volt center ta...dconant — 06:40 PM
54C Cabinet Refinish
Roy; Personally I would have left the asbestos alone if it were my set, but you can find a modern substitute that som...Arran — 04:51 PM
Philco 71 Code 125
Looks like that might be the B- buss, so that would be correct.RodB — 01:32 PM
Philco 71 Code 125
I noticed on the code 121 schematic the center tap for the 6 volt winding and hv winding are tied together. Is this corr...dconant — 12:16 PM
Philco 45-6365 Universal IFT Instruction Manual
The Philco Parts Catalog for 1942 shows it as usable for 175 kHz, 260 kHz, and 465 kHz. The instructions will show how t...DaleHCook — 11:19 AM
Stromberg Carlson 1500 Squeal
Hello Rob, I agree with you—I have one here at my house that I need to check out. It’s way over-engineered just to make...radiorich — 11:05 AM
My Atwater Kent 84
Well getting around to restoring my AK84. Mike was a big part in me being able to snatch this one a few years ago. I won...462ron — 10:57 AM

[-]
Who's Online
There are currently 2142 online users. [Complete List]
» 1 Member(s) | 2141 Guest(s)
Avatar

>