Philco 47-1230 Knobs & phono question

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 47-1230 Knobs & phono question

bill T
Junior Member

Posts: 42
Threads: 9
Joined: Oct 2005

10-12-2006, 06:38 AM

Hi , Does anyone have a photo of a 47-1230 close enough to determine what type of knobs are on it ? I recently picked up this console and most of the units I chose it is not all there.No knobs lifted veneer the usual. I 've looked on line for a couple days without much luck for a decent photo.
Also have ask repo sources if they make a replacement without an answer yet.In fairness it has only been a couple days so maybe an answer is coming yet.
This unit has a phono in it . Mine does not even have a arm on it.I think it is a model d-10a .According to what I read it will have a "dynamic cartridge" in it when I find one.The other cartridge this unit is fit with was a crystal cartridge .So I am thinking this may be a choice when rebuilding.Can anyone give me some general direction or information on this phono section ? I have no experience in this area and want it to work .
Should I put a later model philco phono in it's place rather than try to rebuild this one ? Any help or direction is appreciated !

Thanks !
Bill

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Philco 47-1230 Knobs & phono question - by bill T - 10-12-2006, 06:38 AM

[No subject] - by Ron Ramirez - 10-12-2006, 09:19 AM

[No subject] - by Ron Ramirez - 10-12-2006, 09:31 AM

Good Info !!! - by bill T - 10-12-2006, 08:21 PM

[No subject] - by Ron Ramirez - 10-16-2006, 03:55 PM

[No subject] - by bill T - 10-18-2006, 07:40 PM

[No subject] - by Ron Ramirez - 10-18-2006, 11:21 PM

[No subject] - by Poston Drake - 10-19-2006, 01:03 AM

[No subject] - by bill T - 10-20-2006, 06:57 AM

[No subject] - by bill T - 10-20-2006, 07:26 PM

[No subject] - by 49Stude63 - 10-20-2006, 10:53 PM

[No subject] - by Ron Ramirez - 10-21-2006, 08:30 PM

[No subject] - by bill T - 10-25-2006, 10:54 PM

Final answer on knobs - by bill T - 12-17-2006, 08:40 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me