Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHILCO 70 VS 90
#4

Hi Madghost

The early 70 and early 90 (using two Type 45 output tubes) share the same front end, and neither have AVC.

The "mid" 90, the most common version with a single Type 47 output, uses AVC which makes a HUGE improvement in performance; i.e. no "blasting" as you tune across the dial, and less prone to fading.

The late 90 (push-pull 47 outputs) and late 70 both have autodyne converters, and both have AVC, so again their front ends are similar.

Both are good performers. To make a long story short, the 90 has extra amplification in its audio section. It is slightly larger than the 70. And there is just something special about it, I guess, that makes it more desirable. Icon_smile

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
PHILCO 70 VS 90 - by madghost - 10-23-2006, 10:18 AM
[No subject] - by Terry Burns - 10-23-2006, 01:43 PM
[No subject] - by Chuck Schwark - 10-23-2006, 02:19 PM
[No subject] - by Ron Ramirez - 10-30-2006, 10:36 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

[-]
Who's Online
There are currently no members online.

>