Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Can this dog be fixed?
#1

Picked up a Philco 46-250 at an auction a while back and it is a real dog, but I'd like to see what can be done with it. It has several cracks that have been repaired at one time, mainly on the sides. Some are nice and smooth and even, some aren't. The overall color is an off-white, but there are large patches, especially along the sealed cracks, where it is black or extremely dark brown; hard to tell. There are a lot of little spots around the rest of the radio, though, where the off-white is gone. It's never going to win an award but it doesn't deserve the trash. 1) Can the cracks be smoothed over with something? 2) A new paintjob would do wonders. Would the factory paint wear off like this off-white has, not just where cracks have been repaired? In any case, can someone point me to a good step-by-step source for repainting the case? This will be my first experience doing anything like this. 3) There is some old tape residue along one crack. What will take that off?
Thanks for any ideas you all might have.
Ryan


Messages In This Thread
Can this dog be fixed? - by OzRadio - 11-11-2006, 12:14 AM
[No subject] - by Chuck Schwark - 11-11-2006, 11:00 AM
[No subject] - by Ron Ramirez - 11-12-2006, 12:43 AM
[No subject] - by OzRadio - 11-12-2006, 10:02 AM
[No subject] - by Chris Drumma - 11-14-2006, 01:08 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2143 online users. [Complete List]
» 1 Member(s) | 2142 Guest(s)
Avatar

>