Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Some Philco 70 questions/ANSWERED
#11

Probably.

Philco issued two different Service Bulletins for the early 70. The earlier one, as I recall, had additional mica capacitors across many, perhaps all, of the trimmer condensers; the later "early" version did not.

You should order the complete package from Chuck, he should have both versions of the early 70 service info. And the nominal cost is well worth it for what you receive.

http://www.philcorepairbench.com/schematics.htm

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Some Philco 70 questions/ANSWERED - by DKinYORKpa - 01-01-2012, 03:57 PM
Re: Some Philco 70 questions - by 37silverstreak - 01-01-2012, 04:55 PM
Re: Some Philco 70 questions - by Carl Travis - 01-01-2012, 05:19 PM
Re: Some Philco 70 questions - by DKinYORKpa - 01-01-2012, 06:28 PM
Re: Some Philco 70 questions - by 37silverstreak - 01-01-2012, 06:56 PM
Re: Some Philco 70 questions - by TA Forbes - 01-01-2012, 09:01 PM
Re: Some Philco 70 questions - by 7estatdef - 01-02-2012, 12:41 PM
Re: Some Philco 70 questions - by Keith - 01-05-2012, 06:37 PM
Re: Some Philco 70 questions - by DKinYORKpa - 01-29-2012, 05:01 PM
Re: Some Philco 70 questions/New question/ANYONE? - by Ron Ramirez - 02-08-2012, 09:15 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... The console body has been restored, while the varnish dries reliably I started repairing the chassis.. Of ...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 965 online users. [Complete List]
» 1 Member(s) | 964 Guest(s)
Avatar

>