Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Scored a 41-316RX !
#6

Thanks. It's my first early 40s Philco set. I've never encounter the XXL tubes before.

I started to clean it up this afternoon. The top is pretty rough, but the rest isn't so bad.

[Image: http://farm8.staticflickr.com/7039/68190...fda2_z.jpg]

This is after a GoJo and mineral spirit rubdown. I haven't gotten to the right side yet.
Too bad some knucklehead drilled a hole into the top Icon_evil
[Image: http://farm8.staticflickr.com/7201/69651...c596_z.jpg]


Messages In This Thread
Scored a 41-316RX ! - by Bob Andersen - 03-07-2012, 11:24 PM
RE: Scored a 41-316RX ! - by Jayce - 03-08-2012, 12:13 AM
RE: Scored a 41-316RX ! - by Arran - 03-08-2012, 03:56 AM
RE: Scored a 41-316RX ! - by Arran - 03-08-2012, 01:16 AM
RE: Scored a 41-316RX ! - by TA Forbes - 03-08-2012, 05:08 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-08-2012, 05:47 PM
RE: Scored a 41-316RX ! - by Ron Ramirez - 03-08-2012, 08:37 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-08-2012, 09:25 PM
RE: Scored a 41-316RX ! - by Arran - 03-08-2012, 10:40 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-09-2012, 05:59 PM
RE: Scored a 41-316RX ! - by Arran - 03-09-2012, 09:42 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-09-2012, 11:58 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-10-2012, 08:47 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-11-2012, 03:13 AM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-11-2012, 03:27 AM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-16-2012, 05:04 PM
RE: Scored a 41-316RX ! - by Ron Ramirez - 03-16-2012, 07:10 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-16-2012, 11:52 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-19-2012, 03:30 PM
RE: Scored a 41-316RX ! - by Doug Houston - 03-19-2012, 07:59 PM
RE: Scored a 41-316RX ! - by Arran - 03-20-2012, 01:02 AM
RE: Scored a 41-316RX ! - by Ron Ramirez - 03-19-2012, 10:05 PM
RE: Scored a 41-316RX ! - by Arran - 03-20-2012, 01:12 AM
RE: Scored a 41-316RX ! - by TA Forbes - 03-20-2012, 10:56 AM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-19-2012, 11:37 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-21-2012, 12:17 AM
RE: Scored a 41-316RX ! - by Arran - 03-21-2012, 08:47 PM
RE: Scored a 41-316RX ! - by w4rtc - 03-21-2012, 12:05 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-21-2012, 01:23 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 03-22-2012, 05:56 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 04-03-2012, 04:10 PM
RE: Scored a 41-316RX ! - by Ron Ramirez - 04-03-2012, 09:33 PM
RE: Scored a 41-316RX ! - by Bob Andersen - 06-18-2015, 04:41 PM
RE: Scored a 41-316RX ! - by Warren - 06-18-2015, 10:42 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Pa...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM
Philco Model 38-7: what caps & resistors do fail typically?
Hi all, on vacation in Montreal,  a friend of mine showed me a Philco Model 38-7 console radio from the 30ies. Mechan...Musaeum — 07:21 PM
Part numbers to model cross
I looked thru the documents and did not see one. Might have missed it though.Jim Dutridge — 07:16 PM

[-]
Who's Online
There are currently 1129 online users. [Complete List]
» 3 Member(s) | 1126 Guest(s)
AvatarAvatarAvatar

>