Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need hlp with old crystal cartridge
#3

Thanks, I have purchased the Astratic 51-3 and had to put a counter weight on the back of the tone arm to get the tracking pressure around 10 grams..the recommended tracking pressure for this cartridge is 8 grams. Now my only problem is that it's not enough to trigger the mechanism to shut it off.. But that's ok, I open the door and shut it off that way.. This cartridge puts out .5 volts and it's plenty loud..I tried making adjustments so it would shut off but it's just too much for the needle.
But thanks for the reply... I'm learning as I go.
I'm now working on Philco 42-RP1, it's wireless AM transmitter built into the record player.. The problem I'm having with this one, is that it doesn't transmit very loud.. Not sure if it's the nature of the beast or if theres something wrong, in the schematic it says it should transmit 50 ft. But I have to be right on top of the receiving unit.
I recapped it, and it didn't change anything...
Thanks
Jack


Messages In This Thread
RE: Need hlp with old crystal cartridge - by OldJack1969 - 06-01-2012, 02:30 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 364 online users. [Complete List]
» 1 Member(s) | 363 Guest(s)
Avatar

>