Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 15X-Cabinet questions
#6

Ummm...there should not be any gold painted lines on a 15X. If any are present, they were added after the set left the factory.

But to answer your question...it depends on what type of gold paint was used.

Incidentally, Philco did not use stain on their cabinets...they used tinted lacquer to get the color, something that stain cannot duplicate.

Edit: I think I see what you are talking about now...on either side of the front panel, right? That is inlay veneer, not painted stripes. The inlay will not be adversely affected by stripping.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco 15X-Cabinet questions - by Radioguy52 - 07-29-2012, 10:42 AM
RE: Philco 15X-Cabinet questions - by Ron Ramirez - 07-29-2012, 12:00 PM
RE: Philco 15X-Cabinet questions - by Arran - 07-29-2012, 08:47 PM
RE: Philco 15X-Cabinet questions - by Ron Ramirez - 07-29-2012, 08:55 PM
RE: Philco 15X-Cabinet questions - by Radioguy52 - 07-30-2012, 09:44 AM
RE: Philco 15X-Cabinet questions - by Ron Ramirez - 07-30-2012, 09:58 AM
RE: Philco 15X-Cabinet questions - by Radioguy52 - 07-30-2012, 12:09 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2218 online users. [Complete List]
» 4 Member(s) | 2214 Guest(s)
AvatarAvatarAvatarAvatar

>