Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1209 Phono Questions?
#1

I need to find info on the needle cartridge that's in this Philco 46-1209. Is there a way to check the cartridge to see if it's bad? It's some type of magnetic pickup and if I put my meter across the two inputs at the cartridge i see 120 ohms. The amp needs to be repaired before I can test this one. Are there replacements etc.? I also need an idler for it. Just has a part number on it of 56-2882 and it's 1-5/8" in diameter depending on where you measure. It's badly worn. Here's a picture of the cartridge.
[Image: http://speakeasyradios.com/yahoo_site_ad...39_std.jpg]

Thanks,
Pepper

"It's Nice To Be Nice To The Nice"
Major Frank Burns Mash 4077th


Messages In This Thread
46-1209 Phono Questions? - by Pepperoni - 01-25-2013, 04:56 PM
RE: 46-1209 Phono Questions? - by Marsupial - 01-26-2013, 02:02 AM
RE: 46-1209 Phono Questions? - by Ron Ramirez - 01-26-2013, 09:21 AM
RE: 46-1209 Phono Questions? - by Pepperoni - 01-26-2013, 01:30 PM
RE: 46-1209 Phono Questions? - by Ron Ramirez - 01-26-2013, 07:23 PM
RE: 46-1209 Phono Questions? - by Pepperoni - 01-26-2013, 10:22 PM
RE: 46-1209 Phono Questions? - by Pepperoni - 01-27-2013, 03:54 PM
RE: 46-1209 Phono Questions? - by Ron Ramirez - 01-27-2013, 04:49 PM
RE: 46-1209 Phono Questions? - by Pepperoni - 02-22-2013, 07:04 PM
RE: 46-1209 Phono Questions? - by Pepperoni - 03-09-2013, 05:51 PM
RE: 46-1209 Phono Questions? - by Pepperoni - 03-15-2013, 04:42 PM
RE: 46-1209 Phono Questions? - by Pepperoni - 03-15-2013, 09:34 PM
RE: 46-1209 Phono Questions? - by Ron Ramirez - 03-16-2013, 06:41 AM
RE: 46-1209 Phono Questions? - by Pepperoni - 03-20-2013, 02:46 PM
RE: 46-1209 Phono Questions? - by Ron Ramirez - 03-21-2013, 09:32 AM
RE: 46-1209 Phono Questions? - by Pepperoni - 03-21-2013, 12:37 PM
RE: 46-1209 Phono Questions? - by Ron Ramirez - 03-22-2013, 08:30 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2139 online users. [Complete List]
» 2 Member(s) | 2137 Guest(s)
AvatarAvatar

>