|
philco 42-1012
01-30-2013, 10:24 PM
I would check both output transformers first before pulling the spare one, it seems to be a recurring problem with most of these sets. The good news is that you can likely pull a good one from a scrap chassis of another brand that also has push pull outputs. Any transformer that is used with 6F6s, 42s, 6V6s, 6BQ5s should work fine, 6K6s and 41s not so much.
Regards Arran
« Next Oldest | Next Newest »
Messages In This Thread
philco 42-1012 - by murf - 01-06-2013, 12:21 AM
RE: philco 42-1012 - by TA Forbes - 01-06-2013, 02:41 AM
RE: philco 42-1012 - by shawn - 01-16-2013, 09:48 PM
RE: philco 42-1012 - by murf - 01-16-2013, 10:00 PM
RE: philco 42-1012 - by TA Forbes - 01-16-2013, 10:02 PM
RE: philco 42-1012 - by murf - 01-16-2013, 11:33 PM
RE: philco 42-1012 - by murf - 01-24-2013, 11:53 PM
RE: philco 42-1012 - by TA Forbes - 01-25-2013, 12:44 AM
RE: philco 42-1012 - by Arran - 01-25-2013, 03:00 AM
RE: philco 42-1012 - by murf - 01-27-2013, 06:13 PM
RE: philco 42-1012 - by Electrothaumaturgist - 01-30-2013, 04:54 PM
RE: philco 42-1012 - by Arran - 01-30-2013, 10:24 PM
RE: philco 42-1012 - by murf - 01-30-2013, 10:45 PM
RE: philco 42-1012 - by codefox1 - 01-31-2013, 02:06 PM
RE: philco 42-1012 - by murf - 01-31-2013, 06:19 PM
RE: philco 42-1012 - by Electrothaumaturgist - 01-31-2013, 09:02 PM
RE: philco 42-1012 - by murf - 01-31-2013, 09:14 PM
Users browsing this thread: 1 Guest(s) |
|
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
